You will need to remove the rear drive shaft though to remove the transmission. (make sure to get a new roll pin) 3. Parts can cost anywhere from $320 to $750, for labor expect to spend around $150 to $190. Removing the front drive shaft on your Chevy truck may be necessary if you need to repair the U-joints or if it is blocking access to another component that you may be working on. Do I need to move my "4wd" knob to any particular setting? Put the truck in neutral. REMOVE DRIVE SHAFT (a) Using a brass bar and hammer, remove the drive shaft. What do I need to know or do while the drive shaft is out? I have had to remove the front drive shaft because we (mechanic) thinks that the front dif is gone bad. At this point, I can't afford to have this replaced/repaired. 8. NOTICE: Be careful not to damage the boot, dust cover and oil seal. can i remove the front drive shaft out of my mountaineer 3 Answers. Index the drive shaft with a marker for reinstallation. Is there anything that I should expect? step 1: Removing the Driveshaft (0:37) Have an assistant hold the driveshaft in place or brace it with a pry bar. The rear seal on my front differential is leaking but I can't get the drive shaft out of the diff so I can replace it. Cut the dust boot clamp at the rear of the drive shaft with pliers. Remove the 15mm bolts at the front of the driveshaft. Spray all the bolts that you need to remove on the driveshaft with WD-40 or something similar and allow it to sit for a few minutes, this will make removal much easier. (e) Remove the nut and steering knuckle with axle hub. Right now its in AWD. 2. For a rear wheel or four wheel drive vehicle, expect to … Is there a trick to getting it out? The drive shaft connects to the transfer case at one end and the front pinion yoke on the other. This will allow you to spin the driveshaft to access bolts easier. Good luck. 4. A drive shaft (also called a propeller shaft) is essentially a long rod that is designed to transmit torque from the output shaft of the transmission to the rear differential in a rear wheel drive, four wheel drive, or all wheel drive vehicle. There are no front wheel drive rodeos but there are 4 wheel drive and all wheel drive. But the drive shaft has cover over it , which is slipped back at the transmission end, then the roll pin can be removed from the ujoint end or the drive shaft end, and slipped back toward the front axle, it is a close fit and once you get the shaft off the spline at the transmission end, the front shaft will pull out of the front. i took the front drive shaft out of my mountaineer and it ran good for a few days and now its slipping and the over drive light flashes Welcome! I have clue I might have to remove the rear part (don't know official name) were the drive shaft goes in, … If it is not 4 or all wheel drive then there is no front shafts. To remove the front propshaft you will need to: 1. I have removed the 4 bolts attaching the collar to the front differential and the single bolt at the rear. For replacement of a half-shaft on the front wheel drive car, it will cost you anywhere from $470 to $940. I took the diff a loose and removed the shaft from the engine side but I can't get it to come out the back of the diff. Remove the roll pin that goes through the yoke at the front differential. Remove the right front wheel. Hope this helps. HINT: At the time of installation, please refer to the following items. Step 2 - Drive shaft removal. (b) Using a screwdriver, remove the snap ring from the inboard joint tulip. Slide the propshaft toward the transmission to remove it from the front differential input shaft. Need to remove the drive shaft on a 4wd 1910, what is the trick.